beautypg.com

What to do in emergencies – Dodge 2012 Challenger-SRT - User Guide User Manual

Page 93

background image

If the tire does not inflate to at least 26 psi (1.8 Bar) pressure within 15 minutes:

• The tire is too badly damaged. Do not attempt to drive the vehicle further. Call for

assistance.

NOTE:
If the tire becomes over-inflated, press the Deflation Button to reduce the tire pressure to
the recommended inflation pressure before continuing.

If the tire does not inflate to at least 26 psi (1.8 Bar) pressure within 15 minutes:

• Press the Power Button (4) to turn off the TIREFIT kit.
• Remove the Speed Limit sticker from the top of the Sealant Bottle (1) and place the

sticker on the instrument panel.

• Immediately disconnect the Sealant Hose (6) from the valve stem, reinstall the cap on

the fitting at the end of the hose, and place the TIREFIT kit in the vehicle storage location.
Quickly proceed to (D) “Drive Vehicle”.

(D) Drive Vehicle:
• Immediately after injecting sealant and inflating the tire, drive the vehicle 5 miles (8 km)

or 10 minutes to ensure distribution of the TIREFIT Sealant within the tire. Do not exceed
55 mph (88 km/h).

(E) After Driving:
Pull over to a safe location. Refer to “Whenever You Stop to Use TIREFIT” before continuing.
• Turn the Mode Select Knob (5) to the Air Mode position.
• Uncoil the power plug and insert the plug into the vehicles 12 Volt power outlet.
• Uncoil the Air Pump Hose (7) (black in color) and screw the fitting at the end of hose (7)

onto the valve stem.

• Check the pressure in the tire by reading the Pressure Gauge (3).

If tire pressure is less than 19 psi (1.3 Bar), the tire is too badly damaged. Do not attempt

to drive the vehicle further. Call for assistance.

If the tire pressure is 19 psi (1.3 bar) or higher:
• Press the Power Button (4) to turn on TIREFIT and inflate the tire to the pressure indicated

on the tire and loading information label on the driver-side door opening.

• Disconnect the TIREFIT kit from the valve stem, reinstall the cap on the valve stem and

unplug from 12 Volt outlet.

• Place the TIREFIT kit in its proper storage area in the vehicle.
• Have the tire inspected and repaired or replaced at the earliest opportunity at an

authorized dealer or tire service center.

• Replace the Sealant Bottle (1) and Sealant Hose (6) assembly at your authorized dealer as

soon as possible. Refer to “(F) Sealant Bottle and Hose Replacement.”

WHAT TO DO IN EMERGENCIES

91

This manual is related to the following products: