beautypg.com

Universal garage door opener (homelink®), Before you begin programming homelink, Universal garage door opener – Dodge 2012 Challenger-SRT - User Guide User Manual

Page 69: Homelink®), Electronics

background image

Sound Horn With Lock
• To turn the horn chirp on or off when the doors are locked:

• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds. Then,

press the PANIC button while still holding the LOCK button.

• Release both buttons at the same time.

Flashing Lights With Lock
• The turn signal lights flashing, when the doors are locked or unlocked, feature can be

turned on or off. To turn this feature on or off:

• Press and hold the UNLOCK button for at least 4 seconds, but no longer than 10

seconds. Then, press and hold the LOCK button while still holding the UNLOCK button.

• Release both buttons at the same time.

UNIVERSAL GARAGE DOOR OPENER (HomeLink®)

• HomeLink® replaces up to three hand-held transmitters that operate devices such as

garage door openers, motorized gates, lighting or home security systems. The
HomeLink® unit is powered by your vehicles 12 Volt battery.

• The HomeLink® buttons that are located in the overhead console or sunvisor designate

the three different HomeLink® channels.

• The HomeLink® indicator is located above the center button.

Before You Begin Programming

HomeLink®
• Be sure that your vehicle is parked out-

side of the garage before you begin pro-

gramming.

• For more efficient programming and ac-

curate transmission of the radio-

frequency signal it is recommended that

a new battery be placed in the hand-held

transmitter of the device that is being

programmed to the HomeLink® system.

• Erase all channels before you begin programming. To erase the channels, place the

ignition switch into the ON/RUN position, then press and hold the two outside

HomeLink® buttons (I and III) for up 20 seconds. The Electronic Vehicle Information

Center (EVIC) will display “CLEARING CHANNELS”. Release the buttons when the EVIC

displays “CHANNELS CLEARED”.

NOTE:
• Erasing all channels should only be performed when programming HomeLink® for the

first time. Do not erase channels when programming additional buttons.

• If you have any problems, or require assistance, please call toll-free 1–800–355– 3515 or,

on the Internet at www.HomeLink.com for information or assistance.

ELECTRONICS

67

This manual is related to the following products: