Dodge 2012 Challenger-SRT - Owner Manual User Manual

Page 351

4. Remove the cap from the valve stem and then screw

the fitting at the end of the Sealant Hose (6) onto the

valve stem.
5. Uncoil the Power Plug (8) and insert the plug into the

vehicle’s 12 Volt power outlet.
NOTE:

Do not remove foreign objects (e.g., screws or

nails) from the tire.
(C) Injecting TIREFIT Sealant Into The Deflated
Tire:

• Always start the engine before turning ON the TIRE-

FIT kit.

NOTE:

Manual transmission vehicles must have the

parking brake engaged and the shift lever in NEUTRAL.

• After pressing the Power Button (4), the sealant (white

fluid) will flow from the Sealant Bottle (1) through the

Sealant Hose (6) and into the tire.

NOTE:

Sealant may leak out through the puncture in

the tire.
If the sealant (white fluid) does not flow

within 0 –

10 seconds through the Sealant Hose (6):
1. Press the Power Button (4) to turn Off the TIREFIT kit.

Disconnect the Sealant Hose (6) from the valve stem.

Make sure the valve stem is free of debris. Reconnect the

Sealant Hose (6) to the valve stem. Check that the Mode

Select Knob (5) is in the Sealant Mode position and not

Air Mode. Press the Power Button (4) to turn On the

TIREFIT kit.
2. Connect the Power Plug (8) to a different 12 Volt

power outlet in your vehicle or another vehicle, if avail-

able. Make sure the engine is running before turning ON

the TIREFIT kit.
3. The Sealant Bottle (1) may be empty due to previous

use. Call for assistance.

WHAT TO DO IN EMERGENCIES 349