beautypg.com

After starting, Engine block heater — if equipped – Dodge 2011 Durango - Owner Manual User Manual

Page 343

background image

release it as soon as the starter engages. The starter motor
will disengage automatically in 10 seconds. Once this
occurs, release the accelerator pedal, turn the ignition
switch to the LOCK position, wait 10 to 15 seconds, then
repeat the “Normal Starting” procedure.

CAUTION!

To prevent damage to the starter, wait 10 to 15 sec-
onds before trying again.

After Starting

The idle speed is controlled automatically and it will
decrease as the engine warms up.

ENGINE BLOCK HEATER — IF EQUIPPED

The engine block heater warms the engine, and permits
quicker starts in cold weather. Connect the heater cord to
a standard 110-115 Volt AC electrical outlet with a
grounded, three-wire extension cord.

The engine block heater cord is located:

• 3.6L Engine – coiled and strapped to the engine oil

dipstick tube.

• 5.7L Engine – bundled and fastened to the injector

harness.

The engine block heater must be plugged in at least one
hour to have an adequate warming effect on the coolant.

WARNING!

Remember to disconnect the engine block heater
cord before driving. Damage to the 110-115 Volt AC
electrical cord could cause electrocution.

5

STARTING AND OPERATING

341

This manual is related to the following products: