beautypg.com

Beltalertĥ programming, Beltalert௡ programming – Dodge 2011 Avenger - Owner Manual User Manual

Page 59

background image

occupants to fasten their seatbelts. If the driver seatbelt is
unbuckled while traveling at speeds greater than 5 mph
(8 km/h), BeltAlert

௡ will chime once and illuminate the

Seat Belt Reminder Light, then will proceed to the
96 second warning sequence.

BeltAlert

Programming

NOTE:

Chrysler Group LLC does not recommend de-

activating BeltAlert

௡.

BeltAlert

௡ can be enabled or disabled by your authorized

dealer or by performing the following steps:

NOTE:

The following steps must occur within the first

60 seconds of the ignition switch being turned to the
ON/RUN position. Chrysler Group LLC does not recom-
mend deactivating BeltAlert

௡.

1. With the ignition in the OFF position, buckle the
driver’s seat belt.

2. Turn the ignition switch to the ON/RUN position (do
not start the engine), and wait for the Seat Belt Reminder
Light to turn off.

3. Unbuckle and then re-buckle the driver’s seat belt
three times, ending with the seat belt buckled. This must
be completed within 60 seconds of turning the ignition
switch to the ON/RUN position.

4. Turn the ignition key to the OFF position. A single
chime will sound to signify that you have successfully
completed the programming.

NOTE:

Watch for the Seat Belt Reminder Light to turn

on while the seat belt retracts and turn off while rebuck-
ling the seat belt.

BeltAlert

௡ can be reactivated by repeating this procedure.

NOTE:

Although BeltAlert

௡ is deactivated, the Seat Belt

Reminder Light will continue to illuminate as long as the
driver’s seat belt is unbuckled.

2

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

57