Oil change required — if equipped – Dodge 2011 Avenger - Owner Manual User Manual
Page 208
• Oil Change Required (with a single chime)
• ECO (Fuel Saver Indicator) — If Equipped
• Low Pressure (with a single chime) Refer to ЉTire
Pressure Monitoring System
Љ in ЉStarting and Operat-
ing
Љ.
• Check TPM System (with a single chime) Refer to ЉTire
Pressure Monitoring System
Љ in ЉStarting and
Operating
Љ.
Oil Change Required — If Equipped
Your vehicle is equipped with an engine oil change
indicator system. The Oil Change Required message will
flash in the EVIC display for approximately five seconds
after a single chime has sounded to indicate the next
scheduled oil change interval. The engine oil change
indicator system is duty cycle based, which means the
engine oil change interval may fluctuate dependent upon
your personal driving style.
Unless reset, this message will continue to display each
time you turn the ignition switch to the ON/RUN
position. To turn off the message temporarily, press and
release the MENU button. To reset the oil change indica-
tor system (after performing the scheduled maintenance),
perform the following procedure:
1. Turn the ignition switch to the ON position (Do not
start the engine.)
2. Fully depress the accelerator pedal slowly three times
within 10 seconds.
3. Turn the ignition switch to the LOCK position.
NOTE:
If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure.
206
UNDERSTANDING YOUR INSTRUMENT PANEL