beautypg.com

Dodge 2011 Avenger - Owner Manual User Manual

Page 427

background image

Fluid Level Check – 2.4L Engine
Use the following procedure to check the automatic
transmission fluid level properly:

1. Park the vehicle on level ground.

2. Run the engine at curb idle speed for a minimum of
60 seconds.

3. Apply the parking brake fully.

4. Place the shift lever momentarily into each gear posi-
tion ending with the lever in PARK.

5. Wipe the area around the dipstick clean to eliminate
the possibility of dirt entering the transmission.

6. Remove the dipstick and determine if the fluid is hot
or cold. Hot fluid is approximately 180° F (82° C), which
is the normal operating temperature after the vehicle is

driven at least 15 miles (24 km). Hot fluid cannot be held
comfortably between the fingertips. Cold fluid is at a
temperature below 80° F (27° C).

7. Wipe the dipstick clean and reinsert until seated. Then,
remove dipstick and note the reading.

a. If the fluid is hot, the reading should be in the
crosshatched area marked “HOT” (between the upper
two holes in the dipstick).

b. If the fluid is cold, the fluid level should be between
the lower two holes in the area marked “COLD.”

If the fluid level is low, add sufficient fluid through the
filler (dipstick) tube to bring it to the proper level. Do not
overfill.

7

MAINTAINING YOUR VEHICLE

425