beautypg.com

Voice command, Changing the volume, Electronics – Dodge 2010 Challenger_SRT - Quick Reference Guide User Manual

Page 38

background image

VOICE COMMAND

• The Voice Command system allows you to control your AM, FM radio, satellite radio,

disc player, and a memo recorder. When you press the Voice Command
button

, you will hear a beep. The beep is your signal to give a command. If you

do not say a command within a few seconds, the system will present you with a list of
options. If you ever wish to interrupt the system while it lists options, press the Voice
Command button

, listen for the BEEP, and say your command.

• For vehicles equipped with Video Entertainment System (VES)™, refer to the Voice

Command section of the Uconnect™ User's Manual on the DVD for further details.

• For vehicles not equipped with VES™, refer to your vehicle Owner's Manual on the

DVD for Voice Command information.

Changing The Volume

• Start a dialogue by pressing the Voice Command button

, then say a command

(e.g., “tutorial”).

• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level

while the Voice Command system is speaking. Please note the volume setting for
Voice Command is different than the audio system.

WARNING!

Any voice commanded system should be used only in safe driving conditions and all
attention should be kept on the roadway ahead. Failure to do so may result in an
accident causing serious injury or death.

NOTE: To access the tutorial, press the Voice Command button

. After the BEEP,

say “tutorial”. Press any hard-key or touch the display to cancel the tutorial.

ELECTRONICS

36

This manual is related to the following products: