beautypg.com

Express window feature, Emergency key, Keyless go – Dodge 2010 Challenger_SRT - Quick Reference Guide User Manual

Page 11: Engine starting/stopping - automatic transmission, Engine starting/stopping - manual transmission, Getting started

background image

Express Window Feature

• To remotely lower both front door windows at the same time, press and release the

UNLOCK button and then immediately press and hold the UNLOCK button until the
windows lower to the level desired or until they lower completely.

Emergency Key

• Should the battery in the vehicle or the Key Fob transmitter go dead, there is an

emergency key located in the Key Fob. To remove the emergency key, slide the button
at the top of the Key Fob sideways with your thumb and then pull the key out with your
other hand.

• The emergency key is also for locking the glove compartment.

KEYLESS GO™

Engine Starting/Stopping -
Automatic Transmission

Starting

• Place the shift lever in PARK or NEUTRAL.

• While pressing the brake pedal, press the

ENGINE START/STOP button once. If the
engine fails to start, the starter will
disengage automatically after 10 seconds.

• To stop the cranking of the engine prior to

the engine starting, press the button again.

Stopping

• Place the shift lever in PARK.

• Press the ENGINE START/STOP button once. The ignition switch will return to the OFF

position.

• If the shift lever is not in PARK, the ENGINE START/STOP button must be held for two

seconds and vehicle speed must be above 5 mph (8 km/h) before the engine will shut
off.

NOTE: If the ignition switch is left in the ACC or RUN (engine not running) position and
the transmission is in PARK, the system will automatically time out after 60 minutes of
inactivity and the ignition will switch to the OFF position.

Engine Starting/Stopping - Manual Transmission

Starting

• Press and hold the clutch pedal while pressing and holding the ENGINE START/STOP

button. Release the button when the engine starts. If the engine fails to start within
15 seconds, release the button, wait 10 to 15 seconds, then repeat.

• To stop the cranking of the engine prior to the engine starting, release the button.

9

GETTING STARTED

This manual is related to the following products: