NISSAN 2008 Versa Hatchback - Quick Reference Guide User Manual

Page 15

■ When prompted for a PASSKEY code, enter “1234” from the handset. (The

PASSKEY code is assigned by NISSAN and cannot be changed.)

6. Say a name for the phone when the system asks you to provide one. You can give

the phone a name of your choice.

7. Say a number between 1 and 5 when the system asks you for a priority level. The

priority level determines which phone interacts with the system when two or more

paired phones are active in the vehicle at the same time. Choose 1 if this is the only

phone or the primary phone.

8. Say “Yes” or “No” when the system asks if you would like to select a custom ring

tone. Follow the instructions provided by the system to choose a ring tone.

SETTING UP YOUR PHONE BOOK - ADDING NEW ENTRIES

Each paired phone has its own dedicated phone book. Each phone book can store up to
40 names. Each name can have up to 4 locations/numbers: Home, Office, Mobile, and
Other.

NOTE: The vehicle must be stationary when adding new entries.

1. Press the

button and wait for tone.

2. Say “Phone book.”

3. Wait for the tone, then say “New entry.”

4. When prompted, say the name for the new entry. For example, say “Michelle.” If the

name is too short or too long, or if it sounds too much like a name that is already

stored in the phone book, the system tells you and prompts you to say a name

again. Choose a new name.

5. Say “Yes” or “No” when the system asks you to confirm the name is correct.

6. Say a location (“Home,” “Office,” “Mobile” or “Other”) when the system asks you to

provide one. The system acknowledges the location.

7. When prompted, say a phone number for the location. For example, say “five five

five one two one two.” The system repeats the number and prompts you for the next
command.

■ By Voice command - When prompted, say a phone number for the location. For

example, say “five five five one two one two.” The system repeats the number and
prompts you for the next command.

■ By Bluetooth

transfer - Say “Transfer entry.” The system acknowledges the

command and asks you to initiate the transfer from the phone handset. The
new contact phone number will be transferred from the cellular phone via the
Bluetooth

communication link. The transfer procedure varies according to each

cellular phone. See the cellular phone owner’s manual for details.

8. Say “Store” when you are finished entering numbers. The system confirms the

name, location, and number.

9. Say “Yes” or “No” when the system asks if you would like to store another location

for the same name. If you do not respond to the system prompt, the system ends

the New Entry session.