First drive features, Rear seat adjustments (hardtop models), Rear seat entry/exit (crosscabriolet models) – NISSAN 2014 Murano - Quick Reference Guide User Manual

Page 12

To view detailed instructional videos regarding features in this Quick Reference Guide,

please go to www.nissanownersinfo.mobi.

FIRST DRIVE FEATURES

REAR SEAT ADJUSTMENTS (Hardtop models)

FOLDING DOWN THE REAR SEAT
To fold the seats flat, release the connector tongue of

the rear center seat belt from the buckle, then store
the connector and seat belt tongues in the retractor
base on the ceiling

Fold the seatback forward using either the pull strap

, located on the outside edge of the rear seat, or

the release lever

in the cargo area.

To raise the seatback manually, lift up each seatback

and push it to the upright position until it is latched.

To raise the seatback automatically (if so equipped),

push and hold the power seatback switch located in

the cargo area

or the corresponding seat switch

on the lower side of the instrument panel

– A beep sounds once and the seatback begins to

move automatically.

– A beep sounds twice when the seatback is fully

returned to the upright seating position.

RECLINING THE REAR SEATS
Brace the back of the seat with your arm while

pulling on the strap. The seatback will release quickly.

Pull the reclining strap

, and move the seatback to the desired angle.

Release the reclining strap after positioning the seat at the desired angle.

For more information, refer to the “Safety – Seats, seat belts and supplemental restraint system (section 1)” of your
Owner’s Manual.

REAR SEAT ENTRY/EXIT (CrossCabriolet models)

DRIVER’S SIDE
Pulling the strap behind the driver’s seat does not

slide the driver’s seat forward. You cannot slide the
driver’s seat manually.

To enter the rear seat, push and hold the front end of

the slide switch

to slide the driver’s seat forward.

Then push and hold the front end of the reclining

switch

until the desired angle is obtained.

To exit the rear seat from the driver’s side, pull the

strap

behind the driver’s seat to release the

driver’s seatback. The driver’s seatback will tilt
forward so that you can exit the vehicle.

1591421_14d_Murano_QRG_012714b.indd 10

1/27/14 3:11 PM