Regulatory information -51 – NISSAN 2014 Cube - Owner's Manual User Manual

Page 192

slow down or disconnect the communica-
tion and cause undesired noise. It is
recommended that you turn off the wireless
LAN (Wi-Fi) when using the Bluetooth

functions.

. Set up the wireless connection between a

compatible cellular phone and the in-vehicle
phone module before using the Bluetooth

Hands-Free Phone System.

. Some Bluetooth

enabled cellular phones

may not be recognized by the in-vehicle
phone module. Please visit www.nissanusa.
com/bluetooth for a recommended phone
list and instructions for connecting your
phone.

. You will not be able to use a hands-free

phone under the following conditions:
— Your vehicle is outside of the telephone

service area.

— Your vehicle is in an area where it is

difficult to receive radio waves; such as in
a tunnel, in an underground parking
garage, near a tall building or in a
mountainous area.

— Your cellular phone is locked to prevent it

from being dialed.

. When the radio wave condition is not ideal

or ambient sound is too loud, it may be
difficult to hear the other person’s voice

during a call.

. Immediately after the ignition switch is

pushed to the ON position, it may be
impossible to receive a call for a short
period of time.

. Do not place the cellular phone in an area

surrounded by metal or far away from the in-
vehicle phone module to prevent tone quality
degradation and wireless connection dis-
ruption.

. While a cellular phone is connected through

the Bluetooth

wireless connection, the

battery power of the cellular phone may
discharge quicker than usual. The Blue-
tooth

Hands-Free Phone System cannot

charge cellular phones.

. If the Bluetooth

Hands-Free Phone System

seems to be malfunctioning, see “Trouble-
shooting guide” later in this section. You can
also visit www.nissanusa.com/bluetooth for
troubleshooting help.

. Some cellular phones or other devices may

cause interference or a buzzing noise to
come from the audio system speakers.
Storing the device in a different location
may reduce or eliminate the noise.

. Refer to the cellular phone Owner’s Manual

regarding battery charging, cellular phone
antenna, etc.

This wireless hands-free car kit is based on
Bluetooth technology.

Frequency: 2402 MHz - 2480 MHz

Output power: 4.14 dBm E.I.R.P

Modulation: FHSS GFSK 8DPSK,

p/4DQPSK

Number of channels: 79

This wireless equipment cannot be used for any
services related to life safety because there is
the possibility of radio interference.

REGULATORY INFORMATION

Bluetooth trademark

Bluetooth

is a trademark

owned by Bluetooth SIG, Inc.,
and licensed to Visteon Cor-
poration.

FCC Regulatory information

. CAUTION: To maintain compliance with

FCC’s RF exposure guidelines, use only
the supplied antenna. Unauthorized antenna,
modification, or attachments could damage
the transmitter and may violate FCC regula-
tions.

. Operation is subject to the following two

conditions:

1. this device may not cause interference and

2. this device must accept any interference,

including interference that may cause un-
desired operation of the device

Center display, heater, air conditioner, audio and phone systems

4-51