FORD 2002 Focus v.3 - Manual (Page 77)

Lights
77
Vertical aim adjustment
Your vehicle is fitted with either
VOR (conventional) or VOL (HID)
headlamps. The adjustment
procedure depends on the type of
headlamps fitted. VOR or VOL is
printed on the headlamp lens in the
following positions:
• VOR - on the inboard bottom
surface of the lens.
• VOL - on the inboard top surface
of the lens above the high beam
bulb. You will need to open the
hood in order to view it.
Follow the aim adjustment
procedure for the type of
headlamps fitted to your vehicle.
VOR
1. Park the vehicle on a level
surface approximately 7.6 meters
(25 feet) from a vertical wall or
screen directly in front of it.
2. Measure the height of the
headlamp bulb center from the
ground and mark a 2.5 meters
(8 foot) horizontal reference line on
the vertical wall or screen at this
height. (A piece of masking tape
works well.)
3. Turn on the low beam
headlamps to illuminate the wall or
screen and open the hood.
4. On the wall or screen you will
observe an area of high intensity
light. The top of the high intensity
area should touch the horizontal
reference line. If not, the beam will
need to be adjusted.