FORD 2002 Explorer v.3 - Manual (Page 106)

3. Using both hands simultaneously
press and hold the hand-held
transmitter button and the desired
HomeLink
௡ button. Do not release
the buttons until step 4 has been
completed.
Some entry gates and garage door
openers may require you to replace
step 3 with the procedure in the
“Canadian Programing” section.
4. The red light will flash slowly and then rapidly. Release both buttons
when the red light flashes rapidly.
5. Follow steps 2 through 4 to program the remaining two buttons.
If you do not successfully program the HomeLink
௡ Universal Transceiver
after repeated attempts, refer to Rolling code programing which
follows, or call toll-free customer assistance: 1–800–355–3515 or on the
Internet at HomeLink.jci.com.
Canadian Programming
During programming, your hand-held transmitter may automatically stop
transmitting after two seconds which may not be long enough to
program the HomeLink
௡ Universal Transceiver.
To program your hand-held
transmitters:
• Continue to hold the button on
the HomeLink
௡ Universal
Transceiver.
• Press and re-press the hand-held
transmitter button every two
seconds until the red light
changes from a slow to a fast
flash.
Controls and features
106