beautypg.com

Locks and security – FORD 2003 F-150 v.2 User Manual

Page 81

background image

Tips:
• Do not set a code that uses five of the same number.
• Do not use five numbers in sequential order.
• The factory set code will work even if you have set your own personal

code.

• If you set a second personal code it will erase your first personal code.

Erasing personal code

1. Enter the factory set 5–digit code.

2. Press and hold the 1

• 2 for two seconds. This must be done within

five seconds of completing step 1.

3. Press the 7

• 8 and the 9 • 0 at the same time. This must be done

within five seconds of completing step 2.

Your personal code is now erased and only the factory set 5–digit code
will work.

Anti-scan feature

If the wrong code has been entered 36 times, the keypad will go into an
anti-scan mode. This mode disables the keypad for one minute and the
keypad lamp will flash during this time.

The anti-scan feature will turn off after:
• one minute of keypad inactivity.
• pressing the UNLOCK

control on the remote entry transmitter.

• the ignition is turned to the ON position.

Unlocking and locking the doors using keyless entry

To unlock the driver’s door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate after pressing the first control on
the keypad.

To unlock all doors, press the 3

• 4 control within five seconds.

To lock all doors, press the 7

• 8 and the 9 • 0 at the same time. You

do not need to enter the keypad code first. Note: The interior lamps
will turn off.

Locks and Security

81