beautypg.com

Driver controls – FORD 2003 F-150 v.2 User Manual

Page 66

background image

HomeLink

௡ is now in the train (or learning) mode and can be

programmed at any time beginning with step 2 in the “Programming”
section.

Reprogramming a single HomeLink

button

To program a device to HomeLink

௡ using a HomeLink௡ button previously

trained, follow these steps:

1. Press and hold the desired HomeLink

௡ button. Do NOT release the

button.

2. The red indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink

௡ button, follow step 2 in the “Programming”

section.

For questions or comments, contact HomeLink

௡ at www.homelink.com

or 1–800–355–3515.

Gate Operator & Canadian Programming

During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink

௡ to accept the signal

from the hand-held transmitter.

After completing steps 1 and 2
outlined in the “Programming”
section, replace step 3 with the following:

Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the “cycling” process to prevent
overheating.
• Continue to press and hold the HomeLink௡ button (note step 3 in the

“Programming” section) while you press and release — every two
seconds
(“cycle”) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink

௡. The red indicator light

will flash slowly and then rapidly after HomeLink

௡ accepts the radio

frequency signal.

• Proceed with step 4 in the “Programming” section.

REC

DEL

PLAY

Driver Controls

66