beautypg.com

Homelink wireless control system (if equipped), Driver controls – FORD 2005 Excursion v.3 User Manual

Page 77

background image

1. Locate the trip computer located in the overhead console.

2. Start the vehicle.

3. Press and hold both trip
computer controls. After
approximately eight seconds, the
trip computer will enter CAL mode.
CAL mode is indicated when the
display lights the “CAL” indicator.

4. Release both controls. The display
will return to normal, except that
the CAL indicator will remain lit
until the compass is successfully
calibrated.

5. Slowly drive the vehicle in a circle (less than 3 mph [5 km/h]) until
the CAL indicator turns off. It may take up to five circles to complete
calibration.

6. The compass is now calibrated.

HOMELINK

WIRELESS CONTROL SYSTEM (IF EQUIPPED)

The HomeLink

௡ Wireless Control System, located on the driver’s visor,

provides a convenient way to replace up to three hand-held transmitters
with a single built-in device. This feature will learn the radio frequency
codes of most transmitters to operate garage doors, entry gate operators,
security systems, entry door locks, and home or office lighting.

When programming your HomeLink

௡ Wireless Control System to

a garage door or gate, be sure that people and objects are out of

the way to prevent potential harm or damage.

Do not use the HomeLink

௡ Wireless Control System with any garage

door opener that lacks safety stop and reverse features as required by
U.S. federal safety standards (this includes any garage door opener
model manufactured before April 1, 1982). A garage door which cannot
detect an object, signaling the door to stop and reverse, does not meet
current U.S. federal safety standards. For more information, contact
HomeLink

௡ at: www.homelink.com or 1–800–355–3515.

Retain the original transmitter for use in other vehicles as well as for
future programming procedures (i.e. new HomeLink

௡ equipped vehicle

purchase). It is also suggested that upon the sale of the vehicle, the
programmed Homelink

௡ buttons be erased for security purposes, refer to

Programming in this section.

RESET

MODE

E/M

2005 Excursion (hdw)
Owners Guide (post-2002-fmt)
USA
(fus)

Driver Controls

77