beautypg.com

Replacing tail/brake/turn signal/backup lamp bulbs, Lights – FORD 2006 Taurus User Manual

Page 40

background image

Replacing tail/brake/turn signal/backup lamp bulbs

The tail lamp, brake lamp, turn
signal lamp and backup lamp bulbs
are located in the same portion of
the tail lamp assembly. Follow the
same steps to replace either bulb.

1. Make sure headlamp switch is in
OFF position and open trunk and
remove two plastic mushroom nuts,
five push pins and the plastic cover
from inside the trunk to access the
lamp assembly.

2. Carefully pull the carpet away to
expose the lamp assembly hardware.

3. Remove three nut and washer
assemblies and the lamp assembly
from the vehicle.

4. Remove the bulb socket by
rotating it counterclockwise, then
pulling it out of the lamp assembly.

5. Pull the bulb from the socket and
push in the new bulb.

6. Install the bulb socket into the
lamp assembly by rotating it
clockwise.

7. Install the lamp assembly on the vehicle with three nut and washer
assemblies ensuring the washers on the nuts are flush with the body to
prevent water from entering the trunk.

8. Carefully push the carpet back in to place and install the plastic cover
inside the trunk with five push pins and two plastic mushroom nuts.

2006 Taurus (tau)
Owners Guide (post-2002-fmt)
USA
(fus)

Lights

40