beautypg.com

Low fluid level, Correct fluid level, High fluid level – FORD 2006 Taurus User Manual

Page 216: Adjusting automatic transmission fluid levels, Maintenance and specifications

background image

1. Drive the vehicle 20 miles (30 km) or until it reaches normal operating
temperature.
2. Park the vehicle on a level surface and engage the parking brake.
3. With the parking brake engaged and your foot on the brake pedal,
start the engine and move the gearshift lever through all of the gear
ranges. Allow sufficient time for each gear to engage.
4. Latch the gearshift lever in P (Park) and leave the engine running.
5. Remove the dipstick, wiping it clean with a clean, dry lint free rag. If
necessary, refer to Identifying components in the engine compartment
in this chapter for the location of the dipstick.
6. Install the dipstick making sure it is fully seated in the filler tube.
7. Remove the dipstick and inspect the fluid level. The fluid should be in
the designated areas for normal operating temperature.

Low fluid level

Do not drive the vehicle if the fluid
level is at the bottom of the dipstick
and the outside temperatures are
above 50°F (10°C).

Correct fluid level
The transmission fluid should be checked at normal operating
temperatures 150°F-170°F (66°C-77°C) on a level surface. The normal
operating temperature can be reached after approximately 20 miles (30
km) of driving.

The transmission fluid should be in
this range if at normal operating
temperature (150°F-170°F
[66°C-77°C]).

High fluid level

Fluid levels above the safe range
may result in transaxle failure. An
overfill condition of transmission
fluid may cause shift and/or
engagement concerns and/or possible damage.
High fluid levels can be caused by an overheating condition.
Adjusting automatic transmission fluid levels
Before adding any fluid, make sure the correct type is used. The type of
fluid used is normally indicated on the dipstick and also in the
Lubricant specifications section in this chapter.

DON’T ADD IF IN CROSSHATCH AREA--CHECH WHEN HOT-IDLING

DON’T ADD IF IN CROSSHATCH AREA--CHECH WHEN HOT-IDLING

DON’T ADD IF IN CROSSHATCH AREA--CHECH WHEN HOT-IDLING

2006 Taurus (tau)
Owners Guide (post-2002-fmt)
USA
(fus)

Maintenance and Specifications

216