FORD 2010 Expedition v.2 - Manual (Page 219)

WARNING: Do not sit on top of a buckled safety belt or insert a
latchplate into the buckle to avoid the Belt-Minder
௡ chime. To
do so may adversely affect the performance of the vehicle’s air bag
system
Deactivating/activating the Belt-Minder
ா feature (if equipped)
Read Steps 1 - 4 thoroughly before proceeding with the
deactivation/activation programming procedure.
Note: If you are using MyKey™, the Belt-Minder
௡ cannot be disabled.
Also, if the Belt-Minder
௡ has been previously disabled, it will be
re-enabled after the use of MyKey™. Refer to MyKey™ in the Locks
and security chapter.
The driver Belt-Minder
௡ feature can be deactivated/activated by
performing the following procedure:
Before following the procedure, make sure that:
• The parking brake is set
• The gearshift is in P (Park)
• The ignition switch is in the off position
• The driver and passenger safety belts are unbuckled
WARNING: While the design allows you to deactivate your
Belt-Minder
௡, this system is designed to improve your chances of
being safely belted and surviving an accident. We recommend you
leave the Belt-Minder
௡ system activated for yourself and others who
may use the vehicle. To reduce the risk of injury, do not
deactivate/activate the Belt-Minder
௡ feature while driving the vehicle.
1. Turn the ignition switch to the on position. DO NOT START THE
ENGINE.
2. Wait until the safety belt warning light turns off (Approximately one
minute).
• Step 3 must be completed within 50 seconds after the safety belt
warning light turns off.
3. Buckle then unbuckle the safety belt nine times at a moderate speed,
ending in the unbuckled state.
• After Step 3, the safety belt warning light will be turned on for three
seconds.
Seating and Safety Restraints
219
2010 Expedition (exd)
Owners Guide, 2nd Printing
USA (fus)