FORD 2010 Expedition v.2 - Manual (Page 149)

Erasing HomeLink
ா buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink
௡ buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
௡ is now in the train (or learning) mode and can be
programmed at any time beginning with Step 1 in the Programming
section.
Reprogramming a single HomeLink ா button
To program a device to HomeLink
௡ using a HomeLink௡ button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
௡ button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
௡ button, follow Step 1 in the Programming
section.
For questions or comments, contact HomeLink
௡ at www.homelink.com
or 1–800–355–3515.
Car2U
ா Home Automation System (if equipped)
The Car2U
௡ Home Automation
System is a universal transmitter
located in the driver’s visor that
includes two primary features – a
garage door opener and a platform
for remote activation of devices
within the home. The Car2U
௡
system’s garage door opener
function replaces the common
hand-held garage door opener with a three-button transmitter that is
integrated into the interior of your vehicle. After being programmed for
garage doors, the Car2U
௡ system transmitter can be programmed to
operate security devices and home lighting systems.
Driver Controls
149
2010 Expedition (exd)
Owners Guide, 2nd Printing
USA (fus)