beautypg.com

Attaching child safety seats with tether straps, Seating and safety restraints – FORD 2010 E-450 v.2 User Manual

Page 124

background image

without lifting the front of the child seat. Keeping the child seat just
touching the vehicle seat gives the best protection in a severe crash.
Each time you use the safety seat, check that the seat is properly
attached to the lower anchors and tether anchor, if applicable. Tug the
child seat from side to side and forward and back where it is secured to
the vehicle. The seat should move less than one inch when you do this
for a proper installation.
If the safety seat is not anchored properly, the risk of a child being
injured in a crash greatly increases.
Combining safety belt and LATCH lower anchors for attaching
child safety seats
When used in combination, either the safety belt or the LATCH lower
anchors may be attached first, provided a proper installation is achieved.
Attach the tether strap afterward, if included with the child seat. Refer
to Recommendations for attaching child safety restraints for children
in this chapter.
Attaching child safety seats with tether straps

WARNING: When using forward-facing child safety seats in
vehicles with only two seating positions or the forward-facing

child safety seat cannot be placed in the rear of the vehicle, move the
passenger seat as far back from the instrument panel as possible.

WARNING: Because the last row of seats in the 12 passenger
and 15 passenger configuration is not equipped with LATCH

anchors and is spaced closer to the row of seats in front, Do not use
forward-facing or rear-facing child seats (other than belt-positioning
boosters) in the last row.

Many forward-facing child safety seats include a tether strap which
extends from the back of the child safety seat and hooks to an anchoring
point called the top tether anchor. Tether straps are available as an
accessory for many older safety seats. Contact the manufacturer of your
child seat for information about ordering a tether strap, or to obtain a
longer tether strap if the tether strap on your safety seat does not reach
the appropriate top tether anchor in the vehicle.
The rear seats of your vehicle are equipped with built-in tether strap
anchors located behind the seats as described below.
Attach the tether strap only to the appropriate tether anchor as shown.
The tether strap may not work properly if attached somewhere other
than the correct tether anchor.

Seating and Safety Restraints

124

2010 Econoline (eco)
Owners Guide, 2nd Printing
USA
(fus)

This manual is related to the following products: