beautypg.com

Illuminated entry, Locks and security – FORD 2011 Escape Hybrid v.2 User Manual

Page 108

background image

To replace the battery:

1. Twist a thin coin in the slot of the
IKT near the key ring in order to
remove the battery cover.
Note: Do not wipe off any grease on
the battery terminals on the back
surface of the circuit board.

2. Remove the old battery.
Note: Please refer to local
regulations when disposing of
transmitter batteries.

3. Insert the new battery. Refer to
the instructions inside the IKT for
the correct orientation of the
battery. Press the battery down to
ensure that the battery is fully
seated in the battery housing cavity.

4. Snap the battery cover back onto
the key.

Note: Replacement of the battery will not cause the IKT to become
deprogrammed from your vehicle. The IKT should operate normally after
battery replacement.

Replacing lost Integrated Keyhead Transmitters (IKTs)

If you would like to have your Integrated Keyhead Transmitters
reprogrammed because you lost one, or would like to buy additional
IKTs, you can either reprogram them yourself, or take all IKTs to your
authorized dealer for reprogramming.

How to reprogram your Integrated Keyhead Transmitters (IKTs)

To program a new Integrated Keyhead Transmitter yourself, refer to
Programming spare keys in the SecuriLock

passive anti-theft section

of this chapter. Note: At least two IKTs are required to perform this
procedure yourself.

Illuminated entry

The interior lamps, parking lamps and puddle lamps (if equipped)
illuminate when the Integrated Keyhead Transmitter or the keyless entry
system keypad is used to unlock the door(s).

Locks and Security

108

2011 Escape Hybrid (ehv)
Owners Guide, 2nd Printing
USA
(fus)