beautypg.com

Programming, Driver controls – FORD 2011 Edge v.2 User Manual

Page 104

background image

model manufactured before April 1, 1982). A garage door which cannot
detect an object, signaling the door to stop and reverse, does not meet
current U.S. federal safety standards. For more information, contact
HomeLink

௡ at: www.homelink.com or 1–800–355–3515.

Retain the original transmitter for use in other vehicles as well as for
future programming procedures (i.e. new HomeLink

௡ equipped vehicle

purchase). It is also suggested that upon the sale of the vehicle, the
programmed Homelink

௡ buttons be erased for security purposes, refer to

Programming in this section.

Programming

Do not program HomeLink

with the vehicle parked in the garage.

Note: Your vehicle may require the ignition switch to be turned to the
accessory position for programming and/or operation of the HomeLink

௡.

It is also recommended that a new battery be placed in the hand-held
transmitter of the device being programmed to HomeLink

௡ for quicker

training and accurate transmission of the radio-frequency signal.

1. Position the end of your
hand-held transmitter 1–3 inches
(2–8 cm) away from the HomeLink

button you wish to program (located
on your visor) while keeping the
indicator light in view.

2. Simultaneously press and hold
both the chosen HomeLink

௡ and

hand-held transmitter buttons until the HomeLink

௡ indicator light

changes from a slow to a rapidly blinking light. Now you may release
both the HomeLink

௡ and hand-held transmitter buttons.

Note: Some entry gates and garage door openers may require you to
replace Step 2 with procedures noted in the Gate Operator and
Canadian Programming
in this section for Canadian residents.

3. Firmly press and hold for five seconds and release the
programmed HomeLink

௡ button up to two separate times to activate the

door. If the door does not activate, press and hold the just-trained
HomeLink

௡ button and observe the indicator light.

• If the indicator light stays on constantly, programming is complete
and your device should activate when the HomeLink

௡ button is pressed

and released.

Driver Controls

104

2011 Edge (edg)
Owners Guide, 2nd Printing
USA
(fus)