FORD 2012 Taurus v.2 - Manual (Page 109)

Programming MyKey
௡ Optional Settings
Turn the ignition on using an admin key. To program the optional
settings, use the message center buttons to do the following:
1. Press SETUP until RESET FOR MYKEY SETTINGS is displayed.
2. Press and release the RESET button to display MyKey setup menus.
The first menu shown is:
MYKEY MAX MPH <80 MPH> OFF
3. If you don’t want to change the maximum speed setting, press the
SETUP button to display the next menu. The remaining menus appear as
follows with the default settings shown:
MYKEY MPH TONES 45 55 65
MYKEY VOLUME LIMIT OFF
MYKEY ADVTRAC CTRL ON .
4. On any of the menus press RESET to highlight your choice with the
<…>.
5. Press SETUP to enter your choice. The next optional setting will be
displayed.
6. Repeat Steps 4 and 5 until you are done changing the optional
settings.
Clear MyKey
௡
To reset all MyKeys
௡ as admin keys, do the following:
1. Turn the vehicle on using the admin key.
2. Press SETUP until PRESS RESET TO CLEAR MYKEY is displayed.
3. Press and release the RESET button. HOLD RESET TO CONFIRM
CLEAR is displayed.
4. Press and hold the RESET button for two seconds until ALL MYKEYS
CLEARED is displayed.
Check MyKey
௡ system status
The vehicle system check will provide the status of the following MyKey
௡
parameters:
• MYKEY MILES — This odometer only tracks mileage when a MyKey௡
is used. If mileage does not accumulate as expected, then the MyKey
௡
is not being used by the intended user. The only way to reset this
odometer to zero is by clearing MyKey
௡. If this odometer is lower than
the last time you checked, then the MyKey
௡ system has been recently
cleared.
Locks and Security
109
2012 Taurus
Owners Guide, 2nd Printing
USA (fus)