FORD 2012 Taurus v.2 - Manual (Page 108)

• Low fuel warnings are displayed in the message center followed by a
chime when the distance to empty value reaches 75 miles (120 km).
• The following systems, if equipped, cannot be turned off: reverse
sensing system, blind spot information system (BLIS
௡) with cross
traffic alert and collision warning system.
Optional settings – these settings can be changed
• Vehicle speed is limited to 80 mph (130 km/h). Visual warnings are
displayed followed by a chime when the vehicle speed has reached
80 mph (130 km/h).
• Visual warnings are displayed followed by a chime when a preselected
vehicle speed of 45, 55 or 65 mph (75, 90, or 105 km/h) is exceeded.
• The maximum volume of the audio system is limited to 45%. MYKEY
VOLUME LIMITED will be displayed in the audio system display when
attempting to exceed the limited volume.
• The AdvanceTrac௡ system cannot be turned off. When this optional
setting is on, the MyKey
௡ user will not be able to deactivate the
system. Note: It may be beneficial to deactivate the AdvanceTrac
௡
system if the vehicle is stuck in snow, mud or sand.
Create a MyKey
௡
To program MyKey
௡ on one of the keys programmed to the vehicle,
insert the key that you want to make a MyKey
௡ into the ignition. For
vehicles equipped with push button start, put the intelligent access key
in the backup slot; see the Driving chapter for the location of the
backup slot. Turn the ignition on. Use the message center buttons to do
the following:
1. Press SETUP until PRESS RESET TO CREATE MYKEY is displayed.
2. Press and release the RESET button. HOLD RESET TO CONFIRM
MYKEY will be displayed.
3. Press and hold the RESET button for two seconds until MARK THIS
AS RESTRICTED is displayed.
4. Wait until KEY RESTRICTED AT NEXT START is displayed.
MyKey
௡ is successfully programmed. Make sure you label it so you can
distinguish it from the admin keys. Note: To program the optional
settings go to Step 2 in the Programming MyKey
௡ Optional Settings
section. If your vehicle is equipped with remote start, see the Using
MyKey
௡ with Remote Start Systems section.
Note: The MyKey
௡ can be cleared within the same key cycle that it was
created, otherwise a standard key (administrator key) is required to
clear the MyKey
௡ programming. To clear all MyKeys௡ go to Step 2 in the
Clear MyKey
௡ section.
Locks and Security
108
2012 Taurus
Owners Guide, 2nd Printing
USA (fus)