FORD 2013 Fiesta v.2 - Manual (Page 134)

3. When your vehicle has stopped, move the transmission selector lever
to position P and switch the ignition off.
Fast Restart
If a valid key is not present, the fast restart feature allows you to restart
your vehicle within 20 seconds of switching it off. Press the brake pedal
(automatic transmission) or the clutch pedal (manual transmission) if
the car is stationary. If the car is still moving, press the start button.
After 20 seconds have expired, you can no longer start your vehicle
without the key present inside the vehicle.
Once your vehicle has started, it remains running until you press the
start button, even if a valid key has not been detected. If you open and
close a door while your vehicle is running, the system searches for a
valid key. You are not able to start your vehicle if a valid key is not
detected within 20 seconds.
STARTING A GASOLINE ENGINE
When you start your engine, the idle speed increases to warm the engine
up. If the engine idle speed does not slow down automatically, have your
vehicle checked by an authorized dealer.
Before starting your vehicle, check the following:
• Make sure all occupants have fastened their safety belts.
• Make sure the headlamps and electrical accessories are off.
• Make sure the parking brake is on.
• Move the transmission selector lever to position P (automatic
transmission) or neutral (manual transmission).
• Turn the key to position II.
Note: Do not touch the accelerator pedal.
1. Fully press the brake pedal.
2. Move the transmission selector lever to position P or N.
3. Start the engine. The engine may continue cranking for up to
10 seconds or until it starts.
Note: If you cannot start your engine on the first try, wait for a short
period of time and try again.
If you have difficulty starting the engine when the temperature is below
-13°F (-25°C), press the accelerator pedal slightly and try again.
If you cannot start your engine after three attempts, wait 10 seconds,
then follow this procedure:
1. Fully press the brake pedal.
2. Fully press the accelerator pedal and hold it there.
3. Move the transmission selector lever to position P or N.
4. Start the engine.
Starting and Stopping the Engine 133
2013 Fiesta (fie)
Owners Guide gf, 2nd Printing
USA (fus)