beautypg.com

Universal garage door opener – FORD 2015 Mustang User Manual

Page 119

background image

E188212

3. Press and hold the function button you

want to program for 2 seconds, then
release. Repeat this step. Depending
on your brand of garage door opener,
you may need to repeat this sequence
a third time.

Erasing the Function Button Codes

Note: You cannot erase individual buttons.

E188213

1.

Press and hold the outer two function
buttons simultaneously for
approximately 20 seconds until the
indicator lights above the buttons flash
rapidly.

2. When the indicator lights flash, release

the buttons. You erased the codes for
all buttons.

Reprogramming a Single Button

To program a device to a previously trained
button, follow these steps:

1.

Press and hold the desired button. Do
NOT release the button.

2. The indicator light begins to flash after

20 seconds. Without releasing the
button, follow Step 1 in the
Programming section.

For questions or comments, contact
HomeLink at www.homelink.com or
1-800-355-3515.

Programming to a Genie Intellicode 2
Garage Door Opener

Note: Make sure to program your Genie
Intellicode 2 transmitter with the garage
door opener before you program the
HomeLink buttons.

Note: To program HomeLink to the
transmitter you must first put the
transmitter into programming mode.

B

A

E142661

Red indicator light.

A.

Green indicator light.

B.

1.

Press and hold one of the buttons on
the hand-held transmitter for 10
seconds. The indicator light changes
from green to red, and back to green
again.

2. Press the same button twice to confirm

the change to programming mode. If
done properly, the indicator light
appears red.

116

Mustang (), enUSA, First Printing

Universal Garage Door Opener

(If Equipped)