beautypg.com

Towing – FORD 2015 Fusion User Manual

Page 221

background image

Trailer lamps are required on most towed
vehicles. Make sure all running lights, brake
lights, turn signals and hazard lights are
working.

Before Towing a Trailer

Practice turning, stopping and backing-up
to get the feel of your vehicle-trailer
combination before starting on a trip.
When turning, make wider turns so the
trailer wheels clear curbs and other
obstacles.

When Towing a Trailer

Do not drive faster than 70 mph (113
km/h) during the first 500 miles (800
kilometers).

Do not make full-throttle starts.

Check your hitch, electrical connections
and trailer wheel lug nuts thoroughly
after you have traveled 50 miles (80
kilometers).

When stopped in congested or heavy
traffic during hot weather, place the
gearshift in position P (automatic
transmission) or neutral (manual
transmission) to aid engine and
transmission cooling and to help A/C
performance.

Turn off the speed control with heavy
loads or in hilly terrain. The speed
control may turn off automatically
when you are towing on long, steep
grades.

Shift to a lower gear when driving down
a long or steep hill. Do not apply the
brakes continuously, as they may
overheat and become less effective.

If your transmission is equipped with a
Grade Assist or Tow/Haul feature, use
this feature when towing. This provides
engine braking and helps eliminate
excessive transmission shifting for
optimum fuel economy and
transmission cooling.

Allow more distance for stopping with
a trailer attached. Anticipate stops and
brake gradually.

Avoid parking on a grade. However, if
you must park on a grade:

1.

Turn the steering wheel to point your
vehicle tires away from traffic flow.

2. Set your vehicle parking brake.
3. Place the automatic transmission in

position P or manual transmission in a
low gear.

4. Place wheel chocks in front and back

of the trailer wheels. (Chocks not
included with vehicle.)

Launching or Retrieving a Boat or
Personal Watercraft (PWC)

Note: Disconnect the wiring to the trailer
before backing the trailer into the water.

Note: Reconnect the wiring to the trailer
after removing the trailer from the water.

When backing down a ramp during boat
launching or retrieval:

Do not allow the static water level to
rise above the bottom edge of the rear
bumper.

Do not allow waves to break higher
than 6 inches (15 centimeters) above
the bottom edge of the rear bumper.

Exceeding these limits may allow water to
enter vehicle components:

Causing internal damage to the
components.

Affecting drivability, emissions, and
reliability.

Replace the rear axle lubricant anytime
the rear axle has been submerged in water.
Water may have contaminated the rear
axle lubricant, which is not normally
checked or changed unless a leak is
suspected or other axle repair is required.

218

Fusion/Mondeo (CC7), enUSA

Towing