Integrated universal remote control – BMW X5 4.8is SAV 2004 User Manual

Page 119

117

Overview

Controls

Maintenance

Repairs

Data

Index

Integrated universal remote control

Programming

1 Memory buttons

2 Indicator lamp

Fixed-code hand-held transmitter

1. Switch on the ignition
2. For initial use: press both outer

buttons 1 for approx. 20 seconds,
maintaining pressure until the indica-
tor lamp 2 starts to flash. The three
memory buttons 1 are cleared

3. Hold the original hand-held transmit-

ter at a distance of approx. 2 to 8 in/
5 to 20 cm from the memory but-
tons 1

The required distance between
the hand-held transmitter and

memory buttons 1 depends on the

530us247

relevant system of the original hand-
held transmitter used.

4. Simultaneously press the transmit

button on the original hand-held
transmitter and the desired memory
button 1 of the integrated universal
remote control. Initially, the indicator
lamp 2 flashes slowly. Release both
buttons as soon as the indicator
lamp 2 flashes rapidly If the indicator
lamp 2 does not flash rapidly after
approx. 15 seconds, change the dis-
tance

5. To program other original hand-held

transmitters, repeat steps 3 and 4.

The corresponding memory button 1 is
now programmed with the signal of the
original hand-held transmitter.

The device can be operated as of igni-
tion on.

If the device cannot be operated
after repeated programming,

check whether the original hand-held
transmitter uses an alternating-code
system. To do so, either read the
instructions of the original hand-held
transmitter or press and hold down the
programmed memory button 1 of the
integrated universal remote control.

If the indicator lamp 2 on the integrated
universal remote control flashes quickly
for a brief period and then remains lit up
for approx. two seconds, this indicates
that the original hand-held transmitter is
equipped with an alternating code. In
the case of an alternating-code system,
program the memory buttons 1 as
described at the section on alternating-
code hand-held transmitters.
If you have additional questions, please
consult your BMW Sports Activity Vehi-
cle center or call 1-800-355-3515.
You can also visit this website
www.bmwusa.com.

Alternating-code hand-held
transmitters

To program the integrated universal
remote control, consult the Owner's
Manuals for the equipment to be set.
You will find information there on the
possibilities for synchronization.
When programming alternating-code
hand-held transmitters, please observe
the following supplementary instruc-
tions:

Programming will be easier with
the aid of a second person.