BMW Z4 Roadster 2.5i 2005 - Manual (Page 94)

Replacemen
t pr
ocedures
92
1. Open the caps with a suitable object, e.g. a
coin or screwdriver
2. Fold up the protective cover in the wheel
well.
Headlamp cover
1. Pull the wire clamp out straight
2. Pull the wire clamp past the catches, see
arrows, and fold it down
3. Flip the headlamp cover open and remove.
Reinstall the headlamp cover carefully. If
it is not on tight, the headlamp installation
could be damaged. <
Reinstall the headlamp cover in reverse order.
Low beams and high beams
Left side of engine compartment:
1 Low beams
2 High beams
H7 bulb, 55 watts
The H7 bulb is pressurized. Therefore,
wear safety glasses and protective
gloves. Failure to comply with these precau-
tions could result in physical injury if the bulb is
damaged.
<
1. Turn the bulb holder to the left and pull out
2. Remove and replace the bulb
3. Install in the reverse order.
When cleaning the headlamps, please
observe the instructions in the Caring for
your vehicle brochure. <
Xenon lamps*
The service life of these bulbs is very long and
the probability of a failure is very low, provided
that they are not switched on and off an unusual
number of times. If one of these bulbs should
nevertheless fail, it is possible to continue driv-
ing with great caution using the fog lamps, pro-
vided traffic laws in your area do not prohibit
this.
Because of the extremely high voltages
involved, any work on the xenon lighting
system, including bulb-changing, should be
carried out by technically qualified personnel
only. Otherwise, there is a risk of fatal injury.
<
Online Edition for Part-No. 01 41 0 158 704 - © 10/04 BMW AG