Replacement procedures, Onboard tool kit, Windshield wiper blades – BMW Z4 Roadster 2.5i 2005 User Manual
Page 93: Lamps and bulbs
91
Replacement procedures
Onboard tool kit
The onboard tool kit is stored in a tool pouch. It
is located in the luggage compartment beneath
the floor panel.
Windshield wiper blades
1.
Swich off the ignition
2.
Fold the wiper arm completely out from the
windshield
3.
Place the wiper blade in a position at right
angles to the wiper arm
4.
Press the locking spring
5.
Fold the wiper blade down and unhook it
toward the windshield
6.
Pull the wiper blade past the wiper arm
toward the top
7.
Insert a new wiper blade and apply pressure
until you hear it engage.
Lamps and bulbs
The lamps and bulbs make essential contribu-
tions to the safety of your vehicle. Therefore,
comply fully with the following instructions dur-
ing bulb replacement. If you are not familiar with
the procedures, BMW recommends that you
have your BMW center carry out the work.
Do not touch the glass portion of a new
bulb with your bare hands since even
small amounts of impurities burn in to the sur-
face and reduce the service life of the bulb. Use
a clean cloth, paper napkin or a similar material,
or hold the bulb by its metallic base.
<
A replacement bulb set is available from your
BMW center.
Before working on the electrical system,
switch off the electrical accessory you are
working on or disconnect the cable from the
negative terminal of the battery. Failure to
observe this precaution could result in short cir-
cuits.
To prevent injuries and damage, always comply
with any instructions provided by the bulb man-
ufacturer.
<
Accessing the headlamps
Protective cover in the wheel well
To gain access to the headlamp covers, turn the
front wheels in the required direction.
Online Edition for Part-No. 01 41 0 158 704 - © 10/04 BMW AG