BMW X3 2.5i SAV 2005 - Manual (Page 93)

Under t
h
e
ho
od
92
sure to escape, then continue turning to
open.
3. The coolant level is correct if the upper end
of the red float bar is at least at the same
height as the top edge of the filler neck,
refer to arrow. The bar end may only pro-
trude by a maximum of
ι in/2 cm, i.e. up to
the second mark on the float bar, refer also
to sketch beside the filler neck.
4. If the coolant is low, slowly add coolant up to
the specified level – do not overfill.
5. Screw on the cap and tighten firmly.
6. Have the reason for the coolant loss elimi-
nated as soon as possible.
Brake system
Malfunction
Brake fluid
The warning lamp lights up red despite
the handbrake being released:
Stop immediately.
The brake fluid in the reservoir has fallen to
below the minimum level. At the same time, a
considerably longer brake pedal travel may be
noticeable. Have the system checked immedi-
ately.
During continued driving increased brake
pedal pressure may be necessary, and
considerably longer braking distances may
result. Please adapt your driving style accord-
ingly.
<
Display of the previously described
malfunction on Canadian models.
Brake pads
The warning lamp lights up.
The brake pads have reached their min-
imum pad thickness. Have brake pads
replaced immediately.
For your own safety: use only brake pads
that BMW has approved for your particu-
lar vehicle model. As BMW cannot assess the
suitability of other brake pads for use in your
vehicle, we are unable to assume continued
responsibility for the vehicle's operating safety
if non-approved pads are installed.
<
Online Edition for Part-No. 01 41 0 158 448 - © 09/04 BMW AG