High beams/roadside parking lamps, High-beam assistant, La mp s – BMW M3 Coupe 2010 User Manual

Page 96

High beams/roadside parking

lamps

1 High beams
2 Headlamp flasher
3 Roadside parking lamps

Roadside parking lamps, left or right*

There is an additional option of switching on the
lamps on the side of the car facing the road
when parked.

Switching on

After parking the vehicle, press the lever up or
down beyond the pressure point for a longer
period, arrow

The roadside parking lamps drain the bat-
tery. Therefore, do not leave them on for

unduly long periods of time; otherwise, the bat-
tery might not have enough power to start the
engine.

Switching off

Press the lever in the opposite direction to the
pressure point, arrow

High-beam assistant*

The concept

This system automatically switches the high
beams on and off. The procedure is controlled
by a sensor on the front of the interior rearview
mirror. The assistant ensures that the high
beams are switched on whenever the traffic sit-
uation allows. It handles this task for you and
gives you the benefit of the best possible view.

You can intervene at any time and switch the
high beams on and off as usual.

Activating the system

Turn the light switch to position

3, refer to

page

With the low beams switched on, briefly
push the turn indicator lever in the direction
of the high beam.

The indicator lamp in the instrument
cluster lights up when the high beams
are activated. The system automati-

cally switches from high beams to low beams
and vice versa in response to oncoming traffic,
traffic ahead of you, and adequate ambient
lighting, e.g. on city streets.

Switching the high beams on and off
manually

Whenever you wish, or when the situation
requires, you can intervene:

If the high-beam assistant switches on the
high beams, but you would like to drive with
the low beams, simply switch off the high
beams using the turn indicator lever. This
deactivates the high-beam assistant.
To reactivate the system, briefly push the
turn indicator lever toward the high beams
again.

If the high-beam assistant switches on the
low beams, but you would like to drive with
the high beams, switch on the high beams
as usual. This deactivates the system and
the high beams need to be switched off
manually, if necessary.
To reactivate the system, briefly push the
turn indicator lever toward the high beams
again.

Use the headlamp flasher as usual with the
low beams switched on.

System limitations

The high-beam assistant cannot serve as
a substitute for the driver's personal judg-

ment of when to use the high beams. Therefore,
manually switch off the high beams in situations
where this is required to avoid a safety risk.