FASS T UIM 095G User Manual
Page 14
B.
Install –8 AN hydraulic fitting into fuel line using the following procedures: refer to this procedure
when necessary.
B2.
Secure female end in vise.
A.
Locate a fuel return port into the fuel tank. Most KW’s have a 1/4”, Peterbilts
have 3/8” or 1/2” extra pipe plug located by the fuel lines at the top of the fuel
tank. Other models may have an extra port some where at the top of the fuel
tank. Remove the plugs and install the –8 ANx5/16 NPT into each tank, it may-
be necessary to use a brass bushing.
B1.
Assemble fuel line into female hose fitting (reverse threads), then
apply a modest amount of oil to the interior lining.
B3.
Oil male end of 90° JIC swivel fitting and assemble into female end.
B4.
The male portion should tightened all the way, as seen.
Caution: Do Not use sealant on AN fittings. Only use sealant on threads installed into pump assembly or joining fittings.
Note: No extra ports? - Refer to the option located at the back of the manual.