FASS T F14 200G User Manual
Page 18
G.
Route the fuel line from the “E” port of the FASS to the factory lift
pump’s outlet quick disconnect and cut to length. Insert the PLB-
1238 into FASS fuel line using oil. Slide the PLB-1238 into the facto-
ry quick disconnect until you hear a click. Lock down factory retainer
clip.
H.
Measure between the two factory return fittings. Insert two PLB-12516 fittings into the provided FL-
1002 fuel line using oil. Insert fuel line into factory quick disconnects until you hear a click. Lock
down retainer clip. Secure fuel line.
Note: Secure all fuel lines with cable ties. Cable ties are an economical way to prevent the
possibility of problems occurring!
Blow out any open lines/cover any open ports
Bolts and fasteners properly tightened?
Electrical harness and fuel lines secured and properly tightened? Reconnect the battery.
Has the system been primed?
1. Turn key to the ignition position, turning on the FASS pump for 15 sec..
2. Crank engine and allow to run for at least 1 minute.
Check for leaks.
Start the engine
Recheck all fluid and filter connections for leaks
This pump comes with a 1 Year Manufacturer’s Warranty based on the date it has been manufactured.
To receive your extended Lifetime Warranty, you have 30 days from date of purchase to send the com-
pleted warranty information along with a copy of the purchase receipt in to Diesel Performance Prod-
ucts, Inc. Att: Warranty 16240 Hwy O Suite B Marthasville, MO 63357