FASS T D02 150G - Manual (Page 16)

 Blow out any open lines/cover any open ports
 Bolts and fasteners properly tightened?
 Electrical harness and fuel lines secured and properly tightened? Reconnect the battery.
 Has the system been primed?
1. Turn key to the ignition position, turning on the FASS pump for 15 sec..
2. Crank engine and allow to run for at least 1 minute.
 Check for leaks.
 Start the engine
 Recheck all fluid and filter connections for leaks
 This pump comes with a 1 Year Manufacturer’s Warranty based on the date it has been manufactured.
To receive your extended Lifetime Warranty, you have 30 days from date of purchase to send the com-
pleted warranty information along with a copy of the purchase receipt in to Diesel Performance Prod-
ucts, Inc. Att: Warranty 16240 Hwy O Suite B Marthasville, MO 63357
 Remove inlet fuel line from the factory filter housing. Pinch in tabs and
pull off factory fitting on the inlet side. Unbolt and remove the factory
lift pump. Use a Big Block Chevy block off plate to seal engine block.
Drain filter, blow out fuel lines and cover or plug any open ends.
Note: Secure all fuel lines with cable ties. Cable ties are an economical way to prevent the
possibility of problems occurring!
The factory suction line can be capped off or removed from the truck. Make sure to drain fac-
tory filter. The openings on the filter and tank will need to be capped off to keep debris from
getting into lines or canister.