FASS T D08 260G - Manual (Page 8)

C. Connect the WH-1005 wire harness branch coming from the relay to the factory power source removed
in the Step 1b.
A. Using ring terminals, attach red wire of the WH-1005 to the positive
battery terminal. Attach green wire to a clean ground, preferably the
negative battery terminal. Secure fuse block in a location protected
from outside elements. The use of corrosion preventative spray is
recommended.
The installation of the electrical harness is done first, allowing power to be applied to the pump for
lubrication purposes later in the installation.
B. Disconnect power source to the factory lift pump.
D. Secure Relay in an upright position, as shown, to prevent moisture from entering. Di-electric grease
may be applied to prevent corrosion. Examples of locations to secure relay:
Note: The FASS harness provided has a 15 amp fuse and the 30 amp fuse provided
loose in the kit is to be installed on the wiring harness due to the volume and torque
the FASS pump is producing.
E. Route the WH-1005 wire harness along the frame rail to the mounting location of the FASS fuel
pump.
2003-2004 1998.5-2002