Drew Technologies CarDAQ-Plus - Manual (Page 8)

8
5. Once the Setup Wizard gets to the “Change, repair, remove
installation” page, click on [Repair].
6. Follow the Setup Wizard’s instructions to complete the install.
Updating the Firmware inside your CarDAQ-Plus
The CarDAQ-Plus has updateable firmware. The firmware needs to be
updated every time a new driver and firmware update has been posted
on the Drew Technologies website. The J2534 ToolBox can
automatically update your CarDAQ-Plus firmware for you with a few
easy steps:
Your computer needs to have Internet access. This
process can take up to ten minutes.
1. To update the CarDAQ-Plus firmware, make sure your CarDAQ-
Plus is powered on and connected to your PC. Run the J2534
Toolbox and make sure your CarDAQ-Plus is selected in the
upper right drop down menu. If an update is needed, the
process takes about ten minutes.
2. Next Click on the Support tab, then Device Check.
3. Click on the refresh button next to “Selected Device” at the
upper left. Your CarDAQ-Plus will be found and displayed in the
drop down box.