Dogtra YS500 - Manual (Page 6)

11
CONTACT POINTS
NOTICE :
‐ When first using the "Yapper Stopper", it is
recommended that you start with the lowest level.
If the dog continues to bark, gradually increase the
intensity level.
‐ Once the unit activates, it will go into the delay
mode for 15 seconds before activating again. The
reason the unit does this, is to give ample time for
the dog to process the correction before the unit
activates the next time it barks.
‐ The contact points must always be in contact with the
skin for the unit to function properly.
IMPORTANT : When screwing in the contact points,
tighten them by hand only.
10
SELECTING ON-OFF & INTENSITY
LEVELS.
‐ Level 1 is the lowest setting, while level 7 is the
highest.
‐ By turning the ON/OFF dial clockwise with your
thumbnail, the stimulation intensity increases. The
stimulation decreases when turned counter-
clockwise.
‐ The dial on the collar is used to turn the “No Bark
Collar” on and off and for selecting the intensity
level.
‐ To turn off the “No Bark Collar”, position as shown
above.
(‐ )
Decrease
(+)
Increase