Dogtra 2200 Series - Manual (Page 14)

24
OPERATING
25
OPERATING
Intensity Selection
To select the intensity level, start on the zero
(0) setting. Gradually increase the level until you
get a response from the dog that would be
equivalent to a quick pull or jerk with a leash.
Remember that you will need to adjust the
setting (upward or downward) as the dog’s
attitude changes, especially during times of
increased excitement or distraction.
Prolonged use of the Pager (12 seconds or
longer) will drain the batteries more quickly.
Fitting the Collar
The collar strap should be adjusted so that
the contact points are held firmly against the
dog’s skin. If the collar is too loose, irritation
may result from the contact points rubbing
against the skin.
If the dog has a heavy coat, move the
receiver up and down to work the contact points
down into the coat.
ATTENTION!
Avoid having the dog wear the collar with
the contact points in the same place for more
than two hours at a time. Leaving the points
on the same spot for extended periods of time
can cause skin irritation. If the dog is to wear
the e-collar for long periods, occasionally
reposition the collar so that the contact points
are moved to a different spot on the dog’s
neck.
OPERATING INSTRUCTIONS