Dogtra 2200 Series - Manual (Page 13)

22
TESTING
23
TESTING
1. Turn the collar on by pressing the button
on the back side of the collar receiver. The
indicator light will come on for a moment
then blink once every two seconds,
showing that the collar is ready to use. (If
the indicator light is not green but amber
or red, the batteries need to be charged.)
Place the test light on the contact points of
receiver and hold it there.
TESTING YOUR
COLLAR
2. Watch the test light as you push the “Nick”
button on the transmitter. It should light for
just a moment.
3. Watch the test light as you push the
“Constant” button on the transmitter. It should
glow brightly. As a safety feature, the collar
receiver will automatically shut off stimulation
if the constant button is depressed for twelve
seconds or longer.
4. Change the intensity dial on the transmitter
clockwise and then counterclockwise. The test
light should glow brighter with higher levels
of stimulation and dimmer with lower levels.
NOTE : It is normal for the test light not to
come on if the intensity level is set below
level ten.
5. Pressing the “Pager” button on the side of the
transmitter causes the collar to vibrate for up
to twelve seconds. The collar will reactivate
when you push the button again.