Bissell 1005E - Manual (Page 9)

w w w. b i s s e l l . c o m
9
M
aintenance and care
cAuTIOn:
Upright storage of the
Steam Mop with a wet
mop pad may result in
the formation of white
marks on your floor. To
remove the white marks,
clean area with vinegar.
Tip:
Using distilled or
demineralized water
will maximize the
performance of
your water filter.
Tip:
Be sure to use
only a BISSELL
water filter in
Steam Mop
When you're done
1. Unplug power cord from outlet.
2. Carefully remove mop pad from swivel
head, as mop pad and lower assembly
will be hot.
3. Any water remaining in the water tank
should be emptied prior to machine storage.
4. Mop pad can be machine washed in
warm water. Use only liquid detergants.
Do not use bleach or fabric softeners, for
best results, air dry.
5. Wrap power cord around Quick Release
cord wrap on side of Steam Mop.
6. Wipe all surfaces of Steam Mop with a
soft cloth. Store upright in a protected,
dry area.
IMPORTAnT: do not perform the
maintenance in the note below until
the unit has had time to cool.
nOTe: If steam output is reduced,
the nozzle may be blocked. To
remedy, unplug unit, remove swivel
head from lower body and pour
vinegar through center tube of
swivel head “neck”. clear nozzle by
inserting a paper clip into the brass
spray tip located in bottom of
lower body.
If you fill your Steam Mop cleaner with normal
tap water, it is essential to check the water filter
and replace it when it is no longer effective.
Change the water filter when the bright green
grains turn blue. If the water filter is not changed
at the appropriate time, calcium deposits will
accumulate on the heating element, causing
damage or reduced performance.
Using distilled or demineralized water will
maximize the performance of your water filter.
To order a replacement water filter refer to the
replacement parts section on page 10.
Brass Spray Tip
Swivel head
Neck
Replacing the water filter