Bissell 1005E - Manual (Page 7)

w w w. b i s s e l l . c o m
7
O
perations
Getting ready continued
2. fill the water tank by lifting straight up
and away from unit. Unscrew cap at
bottom of water tank and remove the
insert assembly.
3. fill water tank with water. for best results,
water should be at room temperature. Replace
insert assembly and cap, tighten until snug.
4. Replace water tank by lining up vertical
guides and gently sliding tank into place.
5. Twist the Quick Release cord wrap clockwise to
unwrap the power cord and plug into a proper
grounded outlet as described on page 3.
6. The ready light will illuminate when
Steam Mop is ready for use.
Before you clean
Thoroughly sweep or vacuum floor prior to
cleaning with the Steam Mop.
cleaning hard floors
Steam Mop is designed to clean hard floor
surfaces like ceramic tile, vinyl, laminate,
marble, stone and sealed hard wood floors.
Use of Steam Mop on waxed or unwaxed
floors may result in a diminished glossiness.
Steam Mop is not for use on unsealed wood
floors. Ensure Steam Mop is thoroughly tested
in an inconspicuous area prior to mopping a
large floor area. Also, be sure to check the care
instructions from your flooring manufacturer.
1. Begin cleaning by slowly passing over
the surface while pressing the steam on
demand trigger to emit steam as needed.
nOTe: The trigger does not need to
be depressed at all times for steam
Mop to work satisfactorly.
2. To sanitise an area of your floor, (attack
invisible germs and bacteria) put the center
of Steam Mop over the spot for a minimum
of 15 seconds using continuous steam,
but no longer than 20 seconds. for larger
areas, overlap swivel head placement.
2A 2B
2e
WARnInG:
Never put descaling, aromatic,
alcoholic, or detergent products
into the steam cleaner, as this
may damage it or make it
unsafe for use.
cAuTIOn:
Exercise extreme care when
using the Steam Mop on timber
flooring. Ensure the Steam mop
is thoroughly tested in an incon-
spicuous area prior to mopping
a large floor area. The Steam
Mop generates hot steam, so
when depressing the trigger to
apply steam, ensure the Steam
Mop is moving continuously.
The trigger does not need to
be depressed at all times.
Prolonged application of steam
in one area increases the risk
of damage to the surface treat-
ment on timber floors. Check
with your timber floor treatment
application specialist prior to
Steam Mop operation. Regular
foot traffic and direct sunlight
will wear down timber floor sur-
face treatment making it more
susceptible to extreme care
when using the Steam Mop on
timber flooring.