Bissell 1005E - Manual (Page 8)

O
perations
cleaning hard floors continued
Important: sanitising on timber floors
is not recommended as prolonged
application of steam in one area
increases the risk of damage to the sur-
face treatment on timber floors, espe-
cially in areas with regular foot traffic
and direct sunlight, which will wear
down timber floor surface treatments
making it more susceptible to steam
damage. see cAuTIOn on page 7.
3. When the Steam Mop stops emitting
steam, turn the unit off and unplug it.
Simply remove the water tank, refill,
plug back in, and continue cleaning.
This accessory is recommended for the refreshing
of carpets. once the Steam Mop is cradled in
the carpet refresher attachment, it will easily glide
over the carpet.
nOTe: Always be sure a mop pad is in
place before placing in carpet refresher
attachment. Only white mop pads
should be used with the carpet attach-
ment. do not use carpet attachment on
spots or stains, or glide it over the same
spot for longer than 20 seconds.
1. Attach the mop pad to the swivel mop head.
As directed in step 1 on page 6.
2. Place the swivel mop head, with mop pad
attached, in the carpet refresher attachment.
nOTe: The steam Mop rests in the carpet
refresher attachment and may not stay
attached to the swivel mop head. It is
meant to glide over the carpet.
3. fill the water tank with water. Begin refreshing
your carpet or rug by pushing the Steam Mop
in a forward and backward motion, releasing
steam as you go.
4. When you have finished refreshing your
carpet or rug, unplug the steam mop and
remove from the carpet or rug.
nOTe: Move the steam Mop and
carpet refresher attachment in a
continuous motion until you are fin-
ished. This product is not intended to
be used as a carpet cleaner, only a
carpet refresher or deodorizer. never
attempt to use the steam Mop on
carpet without the carpet refresher
attachment in place. dO nOT leave
the mop in a stationary position.
2
3
carpet Refresher Attachment (select models)
nOTe:
Upon first use of the Steam Mop or
first use of a new water filter, the
pump may make a "KNoCKING"
sound while the water filter fills with
water. This is normal and will last
between 30 seconds to a minute.
Continue to depress the trigger until the
"KNoCKING" subsides and the unit
begins emitting steam.
w w w. b i s s e l l . c o m
8