Bissell 1189E - Manual (Page 5)

www.bissell.com
0844.888.6644
5
Assembly
screw driver required for assembly.
to assemble the unit
1. begin by inserting the body into the foot until
you hear the locking tab click.
2. insert the handle into the body and completely
tighten the screw.
3. install the Hand Vac in place on the body.
to assemble the charging base
1. insert upper cradle into lower base until you
hear the locking tab click.
2. store accessory tools on post of charging base.
charging
before charging make sure the unit is
powered OFF.
1. Plug the adapter into the wall outlet. The red
charging indicator light will illuminate and remain
lit while charging.
2. Charge the unit for 12 hours prior to first use.
The indicator light will change from red to green
when battery is fully charged. Unit will run up to
21 minutes.
3. After initial charging is complete,
approximately 6 hours of charging is required
to regain full capacity.
WaRnInG
Do not plug in your vacuum cleaner until
you are familiar with all instructions and
operating procedures.
1. 2. 3.
1. 2.