B&G Network Speed - Manual (Page 20)

CALIBRATING THE TEMPERATURE SENSOR
Temperature calibration should only be carried out when the
built-in seawater temperature sensor (part of the speed
sensor) is considered to be inaccurate. The temperature of
the water will have to be measured with an accurate
temperature-sensing device; this value can then be entered
into the Network SPEED unit.
In the following example the unit is displaying a reading of
10.4
0 C, the water temperature is known to be 11.4 0 C. The
correct value is entered into the Network SPEED unit.
Press TEMP
key until
TEMP
0 C is
displayed.
Press SETUP
key twice to
display TEMP
CAL. Press ENTER
if to change.
The display
will flash. Press ENTER
key to
memorise the
new units. Press TEMP
key to display
sea
temperature. Use ¿ or À
keys to
change the
displayed
units.
20