Amico NFPA Triplex SCD Modular Stack Mount - Manual (Page 35)

Amico Source | 85 Fulton Way, Richmond Hill, ON, L4B 2N4, Canada Toll Free Tel: 1.877.462.6426 | Tel: 905.764.0800 | Fax: 905.764.0862
www.amico.com 3
Dryer/Filter/Regulator System
• An integral air treatment system with purge saving feature, NFPA 99
after-filters, pressure regulator valves, dew point monitor, CO monitor and
system safety valves
• The
1: 2001 validated in accordance with the requirements of ISO 12500-1 and
includes 3rd PARTY VALIDATION PERFORAMNCE
1. Maximum remaining oil content 0.01 mg/m 3 at 70ºF (21ºC).
2. Particulate removal to 0.01 micron.
3. Dew point [-4ºF medical breathing air applications or -100ºF -
laboratory applications].
4. Air provided shall conform to ISO 8573.1 Standard Class 1.3.1 –
medical breathing air [1.1.1 – laboratory applications].
• Completely pre-piped and prewired to single-point service connections
• There shall be two identical banks of air treatment equipment, piped in
replacement, maintenance and repair work while still treating medical
compressed air through the other set
• Each bank consists of three stages:
Stage 1: Prim
Stage 2: Desiccant heatless
air dryer, equipped with purge
control capable of attaining
pressure dew point of -40ºF
The dry compressed air is
discharged from the “online”
tower into the 3rd stage
Stage 3: P ciency
along with downstream
pressure regulators that will
maintain constant discharge
adjustable)
Air
Receiver
• Receiver shall be rated for full compressor
service and shall be equipped with
a liquid level indicator, electronic timed
automatic drain, manual drain, and a
safety relief valve
• Air receiver should be rated for a
minimum of 200 psig design pressure
• The inside of the receiver consists of a
two-part epoxy coating providing
rust protection equal or better than that
achieved by galvanizing
• Three-valve by pass for service or
replacement without interruption to the
system
33 www.amico.com