Great Plains 1205NT Operator Manual - Manual (Page 48)

1205NT
150-131M 3/28/12
46
Coulters and openers plugging in
no-till conditions Drill at a slight angle to rows.
Small seeds box not emptying
evenly Adjustable divider not set evenly. Move adjustable divider to create
more volume in areas that run out first.
Marker functioning improperly Hose fittings or connections not tight. Check all hose fittings and connec-
tions for oil leaks. See page 17 for
safety message.
Low tractor hydraulic oil level. Add hydraulic oil.
Missing or loose bolts or fasteners. Check and tighten all bolts and fasten-
ers.
Needle valve plugged. Open needle valve, cycle markers
slowly and reset needle valve, refer to
page 39 or page 40.
Marker disk does not mark Marker folding linkage does not have
enough slack to allow marker disk to
drop into field depressions. Maximum down float should be limited
by the slot at rod end of marker cylin-
der. Make sure marker cylinder is fully
extended.
Reverse marker disk to pull or throw
dirt.
Chain Debris, retainer clip Be sure retainer clip is facing opposite
way of chain travel.
Problem Cause Solution