Great Plains 1005 Assembly Instructions - Manual (Page 6)

Great Plains Mfg., Inc.
6 Grease Bank Kit
151-128M 02/20/2008
Install Tubing
28. Select the:
The tubing from the grease bank to the coulters is sup-
plied as a single coil, and must be cut-to-length for each
bulkhead-to-adaptor run. Expect some amount of tubing
to be left over, even with a maximum number of coulters.
Pre-Position Ties
29. Starting about 5in (13cm) from the right end of the
tool bar, lay a cable tie at regular intervals along the
top of the tool bar.
For the model 705, this is about every
5
1 ⁄
4
in (13.3cm).
For the model 1005, this is about every
7
3 ⁄
4
in (19.5cm).
30. When the spacing is satisfactory, loop each tie
around the bar, and insert the tip into the clasp a
short distance (do not tighten the ties at this time).
Route, Cut and Terminate Tubing
For the model 1005, start with the center coulter (odd row
count) or the coulter just right of center (even row count).
For each coulter:
31. Route an end of the uncut tubing from the bulk-
head to the coulter.
If there is an unoccupied hole
in the mount, rout-
ing the tubing through it may be helpful.
Route into the nearest tie loop in the direction of the
coulter, then along the tool bar through ties up to the
coulter mount, and then down to the coulter.
32. Leave enough slack in the tubing for later tightening
of the ties, and avoiding sharp bends (which may
kink). Avoid excess slack and sags.
33. Cut the tubing at the bulkhead and remove it from
any hole used for routing.
34. Remove cap and ferrule from the adaptor .
35. Slide the non-threaded end of the cap and then
the large end of the ferrule onto the tubing .
36. Press the tubing end fully into the adaptor body .
37. Secure the tubing with the cap .
38. At the coulter end, press the tubing end fully into the
grease adaptor.
Qty Call Part Description
14 800-150C CABLE TIE 22.2 LONG REL.
50 or
75 ft
990-109R TUBE NYLON 1/4OD X 062WL
15
22
Figure 8
Bulkhead Tubing Installation
27149
22
4
3
2
1
22
1
22
2 3 4
2
3 22
4
2